Fujitsu AUXG07KVLA Service Manual page 458

¢ Description of display
(1) POWER/MODE
(2) ERROR
(3) MONITOR
Switch
•
SW1 Push
•
•
SW2 Push •
•
SET1-1 DIP For selecting cooling or heating during test operation.
SET1-2 DIP For switching SW1 operation.
SET1-3 DIP (Prohibited)
SET1-4 DIP For outdoor unit low noise operation function.
SET2-1 DIP For selecting outdoor unit low noise operation function.
SET2-2 DIP (Prohibited)
SET2-3 DIP
Changing the current limit
SET2-4 DIP
Be sure to disconnect the power supply or turn off the breaker before changing the DIP switch
setting.
2-1. Setting methods
LED lamp
Green
Red
A Red
B Red
C Red
D Red
E Red
F Red
Function or operation method
For the test run start and stop.
For the pump down start and stop.
For when check run function is activated.
For displaying the check run.
For resetting the Automatic wiring correction memory.
Function or operation method
• Turns on when the power supply is ON (Including
when error occurs).
• Indicate the MODE by the number of flashes when
the installation function is active.
Flashes at high-speed when there is an error.
• Displays the location and contents of errors when
there is an error. (Refer to
05-63 for details.)
• Displays when check run is activated. (Refer to
"Check run" on page 05-56 for details.)
- (05-54) -
"Error code" on page
Factory setting
—
—
OFF
OFF
OFF (Do not change)
OFF
OFF
OFF (Do not change)
OFF
2. Function settings (for outdoor unit)