Indoor Unit (Setting By Wired Remote Controller) - Fujitsu AUXG07KVLA Service Manual

1-3. Indoor unit (setting by wired remote controller)

• The function settings of the control of the indoor unit can be changed by this procedure according
to the installation conditions. Incorrect settings can cause the indoor unit malfunction.
• After the power is turned on, perform the "Function setting" according to the installation conditions
using the remote controller.
• The settings may be selected between the following two: Function number or Setting number.
• Settings will not be changed if invalid numbers or setting numbers are selected.
• This function cannot be used on the secondary units.
¢ Preparation
Before connecting the power supply of the indoor unit, reconfirm following items:
• Piping air tightness test and vacuuming have been performed firmly.
• There is no wiring mistake. Then, connect the power supply of the indoor unit.
1-3. Indoor unit (setting by wired remote controller)
Outdoor unit
Breaker on
- (05-20) -
Indoor units
1. Function settings (for indoor unit)