Summary of Contents for Scotsman Prodigy ELITE A Series
Page 1
Installation and User’s Manual for Air and Water Cooled Modular Cube Prodigy ELITE® A Series Models MC0322, MC0522, MC0722, MC0330, MC0530, MC0630, MC0830, MC1030...
In addition, which provides the user with the information to use the Scotsman ICELINQ® app allows users to connect the product; and Maintenance, which provides the to the machine via Bluetooth® to monitor, control, and user with the information needed keep it operating maintain the ice machine.
MC0322 through MC1030 Air and Water Cooled User Manual Installation: Product Specifications Location Limitations: Environmental Limitations The product is designed to be installed indoors, in a Minimum Maximum controlled environment. Air cooled models discharge Air temperature very warm air into the room out the back. Space must Water temperature be allowed at the sides and back for air discharge.
Model B222 B530P, B842S B948S approved by Scotsman. B322 B330P, B530S, Scotsman reserves the right to make design changes MC0322, Direct fit KBT27 and/or improvements at any time. Specifications and MC0522, available available design are subject to change without notice.
MC0322 through MC1030 Air and Water Cooled User Manual Product Description & Electrical Requirements Dimensions w" x d" x h" Model Series Electrical Condenser Minimum Maximum volts/Hz/ Circuit Fuse Size* phase Ampacity MC0322SA-1 115/60/1 12.7 MC0322SW-1 115/60/1 Water 11.9 MC0322MA-32 208-230/60/1 22.6** x 24 x 23 MC0522SA-1...
Testing has shown that using a filter that does not remove chlorine, such as the Scotsman AquaPatrol™, will greatly improve this situation, while the ice making process itself will remove the chlorine from the ice, resulting in no taste or odor impact.
MC0322 through MC1030 Air and Water Cooled User Manual Panel Removal 1. Locate and disengage the two quarter turn captured screws at the bottom of the front panel. Dataplate Location 2. Pull the front panel out at the bottom. 3. Lift the front panel up and off the machine. 4.
FPT inlet water connection; a 3/8” FPT to 3/8” male Tee the condenser drain into the reservoir or bin drain. flare adapter is available from the local Scotsman distributor or from a hardware store. Vent the reservoir drain. A vertical vent at the back of the drain, extended about 8 - 10”...
MC0322 through MC1030 Air and Water Cooled User Manual Electrical The machine is not supplied with a power cord as the machine is designed to be permanently connected. The dataplate on the back of the cabinet details the power requirements, including voltage, phase, minimum circuit ampacity and maximum fuse size.
MC0322 through MC1030 Air and Water Cooled User Manual Final Check List After connections, Lower Light and Switch Panel 1. Wash out the bin. If desired, the interior of the bin This user accessible panel provides important could be sanitized. operational information and duplicates the lights and switches on the controller.
12. Fill out and mail the warranty registration form or will show a continuous F. Five seconds later the hot register it on line at Scotsman-ice.com. gas valve will close and the harvest assist device Typical Ice Making Cycle Times (minutes).
MC0322 through MC1030 Air and Water Cooled User Manual Adjustments Ice Bridge Thickness Measurement Bridge Thickness - For the Service Tech Only Note: Indentations may be deeper on MC0322 and MC0330 1. Push and hold Off till the machine stops. 1/8-3/16”...
Contact an level drops, the ice machine will resume making ice. authorized Scotsman service agent and have the machine cleaned, de-scaled and sanitized. Caution: Do not place anything on top of the ice machine, including the ice scoop.
The machine will fill up to that level and when it shuts process and then resume ice making. off the Bin Full indicator light will be On. Scan QR code to download the Scotsman ICELINQ™ App: Control Options Connect to this machine via Bluetooth to access additional machine operations, view error information, adjust settings, and initiate self-guided cleaning.
Preparing to Clean: Clean internal parts: 1. Remove the front panel. 6. Mix a cleaning solution of 6oz of Scotsman Clear 1 scale remover with 9 cups (72oz) of 105-115° F 2. Remove the evaporator cover. potable water. Scale Removal: 7.
Page 20
Want more guidance? They are located under the fan blades. The services Scan QR Code to download the Scotsman ICELINQ® of a refrigeration technician will be required to clean App to connect to this machine via Bluetooth® and the condenser.
If so, remove the ice and the machine All Prodigy ELITE® models are Bluetooth® enabled should start in a few minutes. and are compatible with the Scotsman ICELINQ® app, available on both the Apple App Store and To Manually Reset the machine.
Page 22
SCOTSMAN ICE SYSTEMS 101 Corporate Woods Parkway Vernon Hills, IL 60061 www.scotsman-ice.com 800-726-8762 17-3737-01...
Need help?
Do you have a question about the Prodigy ELITE A Series and is the answer not in the manual?
Questions and answers