Black Max BM905530 Operator's Manual page 16

 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-800-726-5760 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not attempt to operate the generator until assembly
is complete. Failure to comply could result in possible
serious personal injury.
LOOSE PARTS LIST
See Figure 3
The following items are included with the generator:
Key
No. Description
1 Axle ......................................................................2
2 Wheel ...................................................................2
3 Washer .................................................................2
4 Hitch Pin ..............................................................2
5 Bolt ......................................................................2
6 Rubber Foot ........................................................2
7 Lock Nut ..............................................................2
8 Bottle of Engine Lubricant ...................................1
Operator's Manual (not shown) ...........................1
TOOLS NEEDED
See Figure 4.
The following tools (not included or drawn to scale) are
needed for assembly:
 Socket Wrenches
 Adjustable Wrench
NOTE: Do not put fuel or lubricant in the generator before
installing the feet and wheels.
ASSEMBLY
INSTALLING FEET
See Figure 5.
 Locate the following items:
2 rubber feet
2 lock nuts
2 bolts
 Insert bolt through rubber foot, then through frame as
shown.
 Thread lock nut onto bolt and tighten one full turn past
snug.
NOTE: Be careful not to overtighten so that foot
material collapses.
 Repeat with remaining foot.
INSTALLING THE WHEELS
See Figure 6.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the same
side as the handle.
 Locate the following items:
2 axles
2 wheels
2 washers
2 hitch pins
 Raise the end of the generator opposite the recoil starter
high enough to gain access to the frame bottom; securely
position props underneath to support.
 Insert the axle through the center of the wheel.
 Place a washer on the axle and then slide the axle through
the bracket on the frame.
Qty.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat the process on the other side.
Page 12 — English