Advertisement
How to remove oven door
You can remove your oven door follow the steps below:
- Open the door so that it is fully open
- Lift up and turn the small levers situation ontop of the hinges on both side
- Grip the door on the two external sides, shut it slowly but not
completely and pull the door towards you, pulling it out of its seat.
Follow the steps backwards to place door back on oven.
Replace oven lamp
WARNING: Ensure that the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock
· Disconnect the oven from the power supply by means of the omnipolar
switch used to connect the appliance to the electrical mains ;or unplug the
appliance if the plug is accessible ;
· Remove the glass cover of the lamp - holder;
· Remove the lamp and replace with a lamp resistant to high temperatures
(300Ԩ) with the following characteristics:
Voltage: 220-240V
Wattage: 2X25W
Type: E 14
Replace the glass cover and reconnect the oven to the mains power supply.
D A N I E L A
Pg 24
P | 0 2 9 6 0 4 1 2 2 6 E | s a l e s @ d a n i e l a a p p l i a n c e s . c o m . a u | W d a n i e l a a p p l i a n c e s . c o m . a u
Installation
Installation of the appliance must be done by a qualified appliance installer who
follows the directions given. Appliances are completely assembled as they
would be under normal use, with no parts removed. Daniela Appliances
declines all liability for faulty installation, which could cause harm to people,
pets, and other property. Important: - Before doing any modifications or
maintenance on the device, the power supply must be turned off.
DANIELA APPLIANCES PTY LTD DOES NOT ACCEPT RESPONSIBILITY FOR
ANY DEFECTS OCCURING DURING INSTALLATION.
The cabinet housing the built-in appliance needs to be suitable for it in order
for it to operate effectively. The cut out measurements for installation under
the counter are shown in the figure below.
The back panel of the cabinet unit must be taken off to ensure appropriate
ventilation. A 20mm space must be left between the oven and the back panel.
The bench top or cook top must have a 50mm clearance from the oven. To
avoid condensation, the oven needs to be entirely sealed off from nearby
cupboards. The adjacent cabinets' panels must be constructed from a heat-
resistant material. Cabinets with a veneer exterior, in particular, must be put
together using glues resistant to temperatures of up to 100 degrees.
Oven and Cabinet Dimensions
U S E R
M A N U A L
D A N 9 0 A B O
D A N I E L A
P | 0 2 9 6 0 4 1 2 2 6 E | s a l e s @ d a n i e l a a p p l i a n c e s . c o m . a u | W d a n i e l a a p p l i a n c e s . c o m . a u
U S E R
M A N U A L
D A N 9 0 A B O
Pg 25
Advertisement
