Table of Contents
Advertisement
AS-Interface Analyser
Fig. 7:
With the protocol description a complete documentation of the actual condition of the
facility is possible. The picture shows the summary of the protocol's first page.
You can reach the protocol in two ways:
• Either after the test run over the main menu "File / Protocol edit". The protocol
contains the won data already.
• Or before a test run over the main menu "Measure / Test assistant". Here a
new statistics is started. The intended measuring time can be entered directly.
At its expiration the protocol sheet appears.
If several protocols are provided without a restart the data once entered manually
are adopted. In particular the description of facility does not need to be entered
a second time. That works also if a protocol which has been already stored (see
below) is loaded.
Subject to reasonable modifications due to technical advances.
21
SIEMENS AG · Low-Voltage Controls · Phone +49 911 895 59 00 · Fax +49 911 895 59 07 · Internet: http://www.siemens.com/lowvoltage/technical-assistance
Functions of the Analyser
This will ease your work substantially, but it can lead to an incorrect
documentation if used imprudently. Example: the stored protocol of a
facility is used as basis for the protocol of another facility. The soft-
ware cannot examine manual entries!
Frequently recurring entries (such as examiners name etc.) can be
put down in a standard protocol which is called by the program cat-
egorically. It must be stored under the file name "default.ptx" in the
directory in which the evaluation software is located.
s
Printed in Germany
Advertisement
Table of Contents
