Table of Contents
Advertisement
Quick Links
INTRODUCTION:
BONDERITE C-AK 9045-6 AERO (known as TURCO 9045-6) is a unique water base carbon remover used to remove
carbon deposits and difficult to remove soils found in aircraft engines. It cleans engine blocks, pistons, carburetors,
transmissions, and brake assemblies. It is an effective carbon remover for jet engine overhaul. It may also remove some
paints.
FEATURES:
Approved by Pratt & Whitney (SPOP 207)
Does not contain chlorinated hydrocarbons, phenols, or chromates
Safe on common engine alloys
Used as received. No mixing or dilution required
Operates at moderate temperatures, 40º to 60ºC
Can be used in Turbulators, Ultrasonic systems or other mechanically agitated tanks
Long lasting
USE INSTRUCTIONS:
Equipment: Tanks may be constructed of mild steel but preferably stainless steel.
1. Preclean parts using an alkaline cleaner or steam cleaner to remove oils, grease, and loose soils. This will
the tank life of BONDERITE C-AK 9045-6 AERO.
2. Water rinse after pre-cleaning. Do not use solvent rinse. Introduction of solvents in BONDERITE C-AK 9045-6 AERO
will decrease the carbon removing properties.
3. Immerse parts in BONDERITE C-AK 9045-6 AERO. Use light mechanical agitation to aid in carbon removing. Time
required is from 30 minutes to 2 hours depending on the contaminates to be removed.
4. The preferred temperatures are 40º to 60ºC. Do not exceed 60ºC. Do not over heat.
5. Remove parts and allow excess to drain back into tank.
6. Rinse with cold or hot water. High pressure rinsings is recommended.
7. Immerse parts in BONDERITE AQUASORB (WATER DISPLACING OIL) to prevent flash rusting of steel parts. Allow
parts to drain without rinsing.
BONDERITE C-AK 9045-6 AERO
WATER BASE CARBON REMOVER
1 of 3
Technical Process Bulletin
(KNOWN AS TURCO 9045-6)
prolong
Advertisement
Table of Contents
Related Manuals for Henkel BONDERITE C-AK 9045-6 AERO
Summary of Contents for Henkel BONDERITE C-AK 9045-6 AERO
- Page 1 (KNOWN AS TURCO 9045-6) INTRODUCTION: BONDERITE C-AK 9045-6 AERO (known as TURCO 9045-6) is a unique water base carbon remover used to remove carbon deposits and difficult to remove soils found in aircraft engines. It cleans engine blocks, pistons, carburetors, transmissions, and brake assemblies.
- Page 2 Allow several minutes for this before taking the reading. Maintenance: 1. For every 0.005 units below 1.070, add 1 gallon of fresh BONDERITE C-AK 9045-6 AERO for every 100 gallons of tank solution.
- Page 3 PHONE: (248) 583-9300 | FAX: (248) 583-2976 | www.henkelna.com/ Trademark usage Except as otherwise noted, all trademarks in this document are trademarks of Henkel Corporation in the U.S. and elsewhere. ® denotes a trademark registered in the U.S. Patent and Trademark Office.
Need help?
Do you have a question about the BONDERITE C-AK 9045-6 AERO and is the answer not in the manual?
Questions and answers