Usage Instructions; Maintenance And Care - body coach PRO 3 Instruction And User's Manual

10 U
SAGE INSTRUCTIONS
Charging
(1) Before initial use, fully charge the battery for up to six (6) hours.
(2) To charge, connect the appropriate plug of the supplied 24V adapter to the battery plug connector,
and then plug the power adapter's power plug into the power outlet.
(3) The LED strip on the battery lights will pulsate to indicate battery charge level and active charging.
(4) Full battery charge is indicated when all LED indicators stop flashing and remain fully lit.
(5) The battery can be charged at any time and at any battery level.
(6) It is not recommended to fully discharge the battery down to the red LED.
(7) Average run time is approximately two (2) hours depending on speed and pressure applied during use.
Usage/massage
(1) Align and attach the battery to the base of the device. Make sure it snaps securely into place (if not
pre-assembled).
(2) With the device turned off, fully insert the desired massage attachment. Pull it out (also with the device
turned off) by pressing remove while pulling it out.
(3) Turn on the device by turning the power switch on the bottom of the battery to ON. Turn off the device
by turning the power switch to OFF.
(4) With the power on, press the button once to turn on the device at level one, twice to turn on the device
at level two, and three times to turn on the device at level three. Pressing the power button again will
turn off the device. The blue LED lights indicate the corresponding power level.
(5) Massage the desired body part at the desired speed, applying more or less pressure as needed.
(6) When changing the massage head, you may apply some vegetable oil to the inner wall of the massage
head or the outer diameter of the massage head rubber ring to increase the degree of lubrication of
the massage head and the mounting hole and make it easier to take out. It is recommended to store
the massage head separately to prevent sticking to the massage gun mounting hole.
11 M
AINTENANCE AND
General information
Using your device will naturally cause wear and tear. This requires regular care and maintenance. Under
normal conditions and use, your device is maintenance-free. However, it is the user's responsibility to
periodically inspect these parts for wear and tear that will affect performance.
Note that the performance of your device can be significantly reduced by the influence of environmental
conditions. Do not expose your device to excessive heat or extreme cold for long periods of time as per-
formance may be affected.
Any modification to the original parts, materials, or construction of the device can significantly reduce
performance. The same applies in the event of heavy soiling or misuse.
Do not use aggressive cleaning agents for cleaning, but remove dirt and dust with a soft, slightly damp
cloth.
Disposal Instructions
(1) This product is shipped in packaging to protect against shipping damage. The packaging materials are
made from raw materials that can be recycled. Please dispose of these materials separately.
(2) If you wish to part with this product, dispose of it according to current regulations. Information can be
obtained from the municipal office.
(3) Batteries do not belong in household waste! Dispose of batteries in an environmentally friendly manner
and dispose of them properly in the interest of the environment. Your local administration will inform
you about collection points and opening times.
C
ARE
EN 10
#28784