Baxi DSGNW 25 User Manual page 13


This function can be activated with the remote control when the unit is in cooling,
dehumidification and automatic (cooling and dehumidification) mode.

The fins that guide the flow of air go back to their initial position in cooling mode.
If the air conditioner is in heating mode,
at low speed before stopping.

The purpose of this function is to dry the heat exchanger in the indoor unit, and
thus prevent condensation which can cause mould and bad
N.B.
a. This function is not factory-set. You can turn it on or off as you
wish. To activate it, follow these steps: with the air conditioner and
the remote control set to "OFF", point the remote control at the
indoor unit and hold down the "Anti-FUNGUS" button.
emits two series of five beeps to indicate that the function is
Once this function has been enabled, unless you turn off the air
conditioner completely or turn off the function manually, the air
conditioning keeps this default function.
b. To turn off this function, follow these steps:
Completely shut down the air conditioner. With the air conditioner
and the remote control set to "OFF", point the remote control at the
indoor unit and hold down the "Anti-FUNGUS" button. The unit will
first emit five beeps, then three, indicating that the function has
been disabled.
c. If the function is activated, it is advisable not to turn the air
conditioner back on before the function has completely finished.
d. This function is not activated when the timer is activated or in night
mode (SLEEP).
14. "SPOT SWING" button
When this button is pressed, the horizontal fins start to swing automatically.
the fins reach the desired position, press the button again so they are fixed in the
selected position.
15. "ECO" button
In cooling mode (COOL), pressing the
When the "ECO" function is on, the air conditioner gives priority to efficient
operation resulting in reduced power consumption.
After 8 hours, this function is turned off automatically. The function can be turned on
again by pressing the "ECO" button.
16. "iFavor" button
The "iFavor" button on the remote control is a shortcut button. Users can store their
preferences regarding operating mode, fan speed, temperature setting and fin tilt.
Whatever the current parameters, pressing this button will restore the previously
saved settings.
Press and hold the "iFavor" button for three seconds until the "iFavor" symbol
appears on the remote control display and flashes three times. This shows that
current settings have been saved. Whichever way you choose to change the
operating status, when you press the "iFavor", the saved settings are restored.
OPERATION
the indoor unit fan runs for three minutes
"ECO" button turns this function on or off.
13
smells.
The unit
ready.
When