Advertisement
Assemble Panels
The front panels are made from thicker 1/4" acrylic to provide more structural rigidity for the
doors. Do not try to bend the 1/4" acrylic!
1. Identify the Corner Connectors
Each of the corners on the enclosure will be held together by the connectors pictured below. There are
only two versions L and R, which can be identified by the letters stamped on the inside. The opposite
connectors are identical, i.e. Bottom Right is the same as Top Left. In all cases the surface of the
connector with the cutout pattern faces front or back.
Top Left
Bottom Left
2. Attach The Door Frame Corners
The front door is designed so that the latches are on the top. Attach the door
connectors on the back side of the door frame using the provided cap head 12mm
screws. See the photos below. The top of the connector should be flush with the top
of the acrylic.
Copyright 2020 3DUPfitters LLC
Top Right
Bottom Right
7
Advertisement
