Advertisement
attaching to the filter and back of the enclosure using M4 cap head 30mm or 40mm screws
depending on the depth of the particular fan.
The air filter should look like this after being attached.
Note that its easier to insert the screws from the
inside, and put the nuts next to the filter housing.
If you didn't purchase an air filter you should just
see a fan, as shown to the right. As with the filter,
make sure the fan is blowing air out of the
enclosure.
7. Attach Top
First move the partially assembled enclosure, the Front, Left Side, and Back, and place
them around the LulzBot Mini 2 as pictured below.
Copyright 2020 3DUPfitters LLC
11
Advertisement
