Setting the Time
The countdown start time can be set in 1-
minute units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least one second.
This causes the hours digits to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the timer
minutes setting.
Watch Operation Guide 3522
6.
Press (C).
This causes [
[
on the display.
7.
Press (D) to select Repeat Timer or Auto
Repeat Timer.
Each press of (D) toggles between
●
[
[
8.
Press (C).
9.
Press (D) to select [♪ON] or [♪OFF] as the
beep setting.
[♪ON]: Tone enabled.
[♪OFF]: Tone disabled.
10.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting a start time of [0:00 00] will
●
perform a countdown of 24 hours.
] (Repeat Timer) or
] (Auto Repeat Timer) to flash
] (Repeat Timer) and
] (Auto Repeat Timer).
Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
Hour, minute, second
2.
Use the operations below to perform a
timer operation.
D
Start
(Countdown starts)
D
Pause
D
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (A).
3.
Press any button to stop the tone.
Note
If flash alert is enabled, display
●
illumination will flash along with the
beeper at the end of the countdown. To
stop the time up beeper (and flash alert
if enabled) after it starts to sound,
press any button.
Configuring Flash Alert Settings
l
15