Table of Contents
Advertisement
Operating the appliance
en
1
Operating the
appliance
Preparing the washing
O p e r a t i n g t h e a p p l i a n c e
machine
The washing machine must be
Note:
correctly installed and connected.
~ Page 26
Connect the mains plug.
1.
Turn on the water tap.
2.
Open the door.
3.
Check that the drum is completely
4.
drained. Drain if necessary.
Select programme/switch on
the appliance
Use the programme selector to select
the required programme. Can be turned
in either direction.
The machine is switched on.
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The indicator lamp for the button lights
up if a setting is active.
16
The settings are not saved when the
appliance is switched off.
Additional settings ~ Page 15
Overview of programmes ~ Page 13
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
Notes
Mix items of laundry of varying sizes.
■
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual items of
laundry may lead to imbalances.
Observe the specified maximum
■
load. Overfilling has a negative
impact on the washing result and
promotes creasing.
Place presorted items of laundry
1.
unfolded in the washing drum.
Make sure that no items of laundry
2.
are trapped between the washing
machine door and the rubber seal,
and close the door.
The Start/Pause ! button indicator
lamp flashes and the programme
settings continue to be displayed on the
display panel one after another. It is
possible to change the settings.
Advertisement
Table of Contents
