Subscribe to Our Youtube Channel
Related Manuals for Tailfin AeroPack
Summary of Contents for Tailfin AeroPack
- Page 1 AeroPack Assembly Instructions Torx T25 Wrench & Torque Wrench 20 minutes www.tailfin.cc support@tailfin.cc for further assistance...
- Page 2 AeroPack What’s included AP20 Top Bag Arch Connector Parts Fast Release Dropouts* Axle* * For ‘Axle + Fast Release Dropout’ option If Direct Mounting click here...
- Page 3 Orientate Arch and Fast Release Dropouts Step One Use the Tailfin logo to orientate the Arch. The logo is legible when stood behind the bike. This will ensure panniers are also at the correct angle Place Dropout on Arch. The sloped side of the...
- Page 4 Attach Fast Release Dropouts Step Two Attach Dropouts to the Arch using the countersunk screws included. Tighten screws in turn to...
- Page 5 Attach Connector Parts (i) Step Three Install first Connector piece by pushing in place Install small Connector piece to Arch Rotate both parts together Screw together using shorter M5*10mm screw. Tighten to 5Nm...
- Page 6 Attach Connector Parts (ii) Step Four Align front Connector Part. Ensure the bag strap is seated under the connector Install part using countersunk screws. Tighten screws in turn to...
- Page 7 Connect Arch to Bag Step Five Ensure Arch is correctly aligned as shown. Using remaining countersunk screws attach the Arch to the bag Tighten screws in turn to Silver pins should face up...
- Page 8 Attach AeroPack to Bike Step Six Open Fast Release Dropouts Clamp Dropouts in place around Axle/Frame Mount Adaptors Close Seat Post Connector in place...
- Page 9 Step Seven Ensure ’teeth’ of the Seat Post Connector are closed by pushing on the lever. Correct Clamp is locked, ready to ride DO NOT use the release button to attach the AeroPack Clamp is unlocked, do not ride Incorrect...
- Page 10 Anti-Theft Screws Optional Step A Security Torx key and screws are included with each set of Fast Release Dropouts √ Install the screws to lock the Fast Release Dropouts to your axle...
- Page 11 Bag Compression Optional Step To compress the bag, open the Direct Access Pocket before you roll the bag shut. This will help remove excess air and reduce the bag’s size. Close the zip to finish...
- Page 12 Stacking Straps Optional Step If you are travelling light, cross the two straps over into an ‘X’ to prevent them from moving around...
- Page 13 AeroPack Assembly Instructions www.tailfin.cc support@tailfin.cc for further assistance...
Need help?
Do you have a question about the AeroPack and is the answer not in the manual?
Questions and answers