Subscribe to Our Youtube Channel
Related Manuals for Tailfin AP20
Summary of Contents for Tailfin AP20
- Page 1 AP20 Trunk Top Bag Assembly Instructions Torx T25 Wrench & Torque Wrench 15 minutes www.tailfin.cc support@tailfin.cc for further assistance...
- Page 2 AP20 Trunk Top Bag What’s included Trunk Top Bag Front Connector Rear Connector 4 x M5*12mm Countersunk Screws...
- Page 3 Install Front Connector Step One Attach Front Connector to bag using two of the screws provided. Partially remove rubber cover for easier installation Ensure front strap is underneath the connector Tighten each screw in turn to 5Nm Slide rubber cover back in place...
- Page 4 Install Rear Connector Step Two Attach Rear Connector to the bag using the two remaining screws You may need to rotate the connector when initially installing the screws Tighten each screw in turn Use a torque wrench and tighten screws to 5Nm...
- Page 5 Attach to Tailfin Rack Step Three Place Front Connector under Top Stay Align rear of bag with Rack and pull open pins until the bag seats in position Push rear connector pins all the way in. CHECK that the bag is fully...
- Page 6 Bag Compression Optional Step To compress the bag, open the Direct Access Pocket before you roll the bag shut. This will help remove excess air and reduce the bag’s size. Close the zip to finish...
- Page 7 Stacking Straps Optional Step If you are travelling light, cross the two straps over into an ‘X’ to prevent them from moving around...
- Page 8 AP20 Trunk Top Bag Assembly Instructions www.tailfin.cc support@tailfin.cc for further assistance...
Need help?
Do you have a question about the AP20 and is the answer not in the manual?
Questions and answers