Advertisement
Quick Links
½"-3" Air/Vacuum Valve
Models 100S to 103S
Operation, Maintenance and
Installation Manual
INTRODUCTION ............................................ 1
RECEIVING AND STORAGE ......................... 1
DESCRIPTION OF OPERATION ................... 1
INSTALLATION .............................................. 2
VALVE CONSTRUCTION .............................. 2
MAINTENANCE ............................................. 2
TROUBLESHOOTING ................................... 3
DISASSEMBLY .............................................. 3
REASSEMBLY ............................................... 3
PARTS & SERVICE ....................................... 4
WARRANTY ................................................... 4
®
VAL-MATIC
VALVE AND MANUFACTURING CORP.
9 05 R i ver s id e D r .
Phone (630) 941-7600 ●
www.valmatic.com
Manual No.
A/VV-OM1-4
●
Elmhurs t, IL 60126
Fax (630) 941-8042
Advertisement
Related Manuals for Val-Matic 100S
Summary of Contents for Val-Matic 100S
- Page 1 Manual No. A/VV-OM1-4 ½"-3" Air/Vacuum Valve Models 100S to 103S Operation, Maintenance and Installation Manual INTRODUCTION ..........1 RECEIVING AND STORAGE ......1 DESCRIPTION OF OPERATION ....1 INSTALLATION ..........2 VALVE CONSTRUCTION ......2 MAINTENANCE ..........2 TROUBLESHOOTING ........3 DISASSEMBLY ..........
-
Page 2: Receiving And Storage
For waste-water and other high turbidity applications, use Val-Matic Series 300A Sewage Air/Vacuum Valves. CAUTION This valve is not intended for fuel service or fluids containing suspended solids. FIGURE 1. ½"-3" AIR/VACUUM VALVE The valve is a float-operated, resilient-seated valve designed to handle clean fluids. -
Page 3: Installation
DESCRIPTION OF OPERATION (Cont'd) The only moving parts in the valve are the float Table 1. ½”-3” Air/Vacuum Valve Parts List and the float guide. The float guide assures that Item Description Material the float enters the seat at the optimum angle Body Cast Iron and assures that the float will not make contact... - Page 4 1. Close inlet shut-off valve. Open drain valve MAINTENANCE (Cont'd) 1. Close the inlet shut-off valve. or remove drain plug. Remove the cover bolts (7) on the top cover. 2. Open the drain valve to allow the fluid in the valve to drain.
-
Page 5: Parts And Service
Parts and service are available from your local representative or the factory. Make note of the valve Size, Series No, and Serial No. located on the valve nameplate and contact: Val-Matic Valve and Mfg. Corp. 905 Riverside Drive Elmhurst, IL 60126 Phone: (630) 941-7600 Fax: (630) 941-8042 www.valmatic.com...