Table of Contents
Advertisement
Quick Links
1-16 in. FloodSafe
Operation, Maintenance and
INTRODUCTION ............................................... 1
RECEIVING AND STORAGE ........................... 1
DESCRIPTION OF OPERATION ...................... 1
INSTALLATION ................................................. 2
CONSTRUCTION ............................................. 2
MAINTENANCE ................................................ 3
TROUBLESHOOTING ...................................... 3
DISASSEMBLY ................................................. 3
REASSEMBLY .................................................. 3
FIELD TESTING ............................................... 4
TEST REPORT ................................................. 5
PARTS AND SERVICE ..................................... 6
WARRANTY...................................................... 6
Installation Manual
®
Inflow Preventer
®
VAL-MATIC
VALVE AND MANUFACTURING CORP.
9 05 R i ver s id e D r .
Phone (630) 941-7600 ●
www.valmatic.com
Manual No.
FS-OM1-5
●
Elmhurs t, IL 60126
Fax (630) 941-8042
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Val-Matic FloodSafe Inflow Preventer
Summary of Contents for Val-Matic FloodSafe Inflow Preventer
- Page 1 FIELD TESTING ..........4 TEST REPORT ..........5 PARTS AND SERVICE ........6 WARRANTY............6 ® VAL-MATIC VALVE AND MANUFACTURING CORP. 9 05 R i ver s id e D r . ● Elmhurs t, IL 60126 Phone (630) 941-7600 ●...
- Page 2 ® 1-16 in. FloodSafe Inflow Preventer OPERATION, MAINTENANCE AND INSTALLATION INTRODUCTION This manual will provide you with the information to properly install, maintain and ensure a long service ® life for the FloodSafe inflow preventer. ® FloodSafe is to be installed on the outlet of an air release or air/vacuum valve to prevent cross contamination of the potable water system due to flooding and malicious tampering as described in...
- Page 3 ® INSTALLATION FLOODSAFE CONSTRUCTION ® The standard FloodSafe is constructed of ductile Remove the packing from the top and bottom of ® the FloodSafe that is used to protect the floats iron. Stainless steel type 316 float checks are the during shipping.
- Page 4 MAINTENANCE 3. Remove the seat (4) by pulling it upward and out of the chamber. Tilt the chamber to remove the ® The FloodSafe requires no scheduled lubrication or float check (5). maintenance. 4. The upper chamber is removed in the same ®...
- Page 5 TEST LOWER CHAMBER FIELD TESTING THE FLOODSAFE 5. Connect the test pipe to test cock A in the lower chamber as shown in Figure 4. A quick- ® The FloodSafe inflow preventer should be tested disconnect coupling is provided to facilitate the after installation, and periodically thereafter as assembly.
- Page 6 ® FloodSafe Inflow Preventer TEST AND MAINTENANCE REPORT OWNER: _________________________________________________________________________________ ADDRESS: ________________________________________________________________________________ LOCATION OF ASSEMBLY: __________________________________________________________________ MANUFACTURER: _________________________ MODEL NO: ____________________________________ YEAR OF MANUFACTURE: _______________________ SIZE: ____________________________________ PROCEDURE: See “FIELD TESTING THE FLOODSAFE” in the Instruction Manual. 1. Isolation Valve 2.
- Page 7 Parts and service are available from your local representative or the factory. Make note of the Valve Size and Model Number located on the valve nameplate and contact: Val-Matic Valve and Manufacturing Corp. 905 Riverside Drive Elmhurst, IL 60126 Phone: (630) 941-7600 Fax: (630) 941-8042 www.valmatic.com...
Need help?
Do you have a question about the FloodSafe Inflow Preventer and is the answer not in the manual?
Questions and answers