Removing Laundry/Switching Off The Appliance; Appliance Settings - Bosch WNA14400GR User Manual And Installation Instructions

Table of Contents

Advertisement

If you do not take laundry out within
15 mins after drying process
finished, wrinkle guard process will
start to prevent laundry getting
wrinkled. The process lasts about 30
minutes. 0:00, £'˜, £© and "Ÿš will
be displayed alternately on the
display and V symbol will be
displayed as the status symbol. You
can touch any button to terminate
this process, then the door will be
released and laundry can be taken
out.
Removing laundry/switching
off the appliance
Set programme selector to Off.
1.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
Leave the door and detergent
drawer open so that any residual
water can evaporate.
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.

Appliance settings

Q
Appliance settings
Y ou can change the following settings:
A p p l i a n c e s e t t i n g s
The volume of the end signal.
The volume of the button signal.
Switching the drum care information
signal on/off.
You will need to activate the setting
mode in order to change these settings.
1/2/3/4...
positions on the
programme selector
Activate setting mode:
Set the programme selector to
1.
position 1. The appliance is switched
on.
Touch and hold the 0 Στύψιμο
2.
(Spin Speed) button and, at the
same time, turn the programme
selector clockwise to position 2.
Release the 0 Στύψιμο (Spin
Speed) button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume and drum care
information
Use the Λήξη σε/Διάρκεια (Finish in/
Time Dry) button to change the
following settings at the corresponding
programme selector positions:
2: The volume of the end signal.
3: The volume of the button signals.
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
en
41

Advertisement

Table of Contents
loading

Table of Contents