End Of The Programme; Removing Laundry/Switching Off The Appliance - Bosch WNA14400TH User Manual And Installation Instructions

Hide thumbs Also See for WNA14400TH:
Table of Contents

Advertisement

For washing programmes at low
temperature:
Touch Start/Pause A button.
1.
Select 0 Spin.
2.
Touch Start/Pause A button.
3.
For drying programmes:
Select 5 Intensive Dry or ‰ Gentle
1.
Dry .
Touch Dry 5 button, and set drying
2.
time to 15 minutes.
Touch Start/Pause A button.
3.

End of the programme

End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
Start/Pause A button to start the final
drain/spin cycle.
Notes
The programme continues by
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
approx. 1 minute after the
programme starts, touch the Start/
Pause A button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
If Hot flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Operating the appliance
Wrinkle guard process starts after
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. 0:00 will be
displayed in time display and V
symbol will be displayed as the
status symbol. You can press any
button or rotate the programme
selector to another position to
terminate this process, then the door
will be released and laundry can be
taken out.
Removing laundry/switching
off the appliance
Set programme selector to Off.
1.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
Leave the door and detergent
drawer open so that any residual
water can evaporate.
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
en
39

Advertisement

Table of Contents
loading

Table of Contents