LG WT-S11WH Owner's Manual page 37

Symptoms
Control panel has powered
off due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is
tripped/blown.
Washing machine
will not operate
Control needs to be reset.
啓動/暫停 (START/PAUSE)
was not pressed after a cycle
was set.
Extremely low water
pressure.
Washing machine is too cold.
Washing machine is heating
the water or making steam.
Filter clogged.
Supply hoses may be kinked.
Washing machine
not filling
properly
Insufficient water supply.
Hot and cold supply hoses
are reversed.
Reason Solution
• This is normal. Press the
電源開/關 (POWER/Auto Off) button to turn
the washing machine on.
• Make sure cord is plugged securely into a
working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly, close the
door and press the 啓動/暫停 (START/PAUSE)
button.
• Close the door and make sure that nothing is
caught under the door preventing it from closing
completely.
• Check house circuit breakers/fuses. Replace
fuses or reset breaker. The washing machine
should be on a dedicated branch circuit. The
washing machine will resume the cycle where it
stopped once power is restored.
• Press the 電源開/關 (POWER/Auto Off)
button, then reselect the desired cycle and
press the 啓動/暫停 (START/PAUSE) button.
• Press the 電源開/關 (POWER/Auto Off) button
then reselect the desired cycle and press
the 啓動/暫停 (START/PAUSE) button. The
washing machine will shut off if the
啓動/暫停 (START/PAUSE) button is not
pressed within 60 minutes.
• Check another tap in the house to make sure
that household water pressure is adequate.
• If the washing machine has been exposed to
temperatures below freezing for an extended
period of time, allow it to warm up before
pressing the 電源開/關 (POWER/Auto Off)
button.
• The washing machine drum may stop operating
temporarily during certain cycles, while water is
safely heated to a set temperature.
• Make sure the inlet filters on the fill valves are
not clogged.
• Check that supply hoses are not kinked or
clogged.
• Make sure that both hot and cold water taps are
turned on all the way.
• Check supply hose connections.
EN
37