Setting The World Time City; Alarm And Hourly Time Signal; Configuring Alarm Settings - Casio G-Shock Frogman GW-8230B-9AER Operation Manual

Setting the World Time City

Use the procedure in this section to select a
World Time city. If you are in an area that
observes summer time, you can also
configure a summer time setting.
1.
Enter the World Time Mode.
Navigating Between Modes
l
2.
Press (D) to display the city code of the
currently selected city.
Holding down (D) scrolls through
●
settings at high speed.
To select UTC (Offset: 0) as the city
●
code, press (B) and (D) at the same
time.
For information about city codes, see
●
the information below.
City Table
l
City code
3.
If you want to configure the summer time
setting, hold down (A) for at least two
seconds.
[DST] is displayed along with summer
time.
Each time you hold down (A) for at least
●
two seconds, the setting toggles
between standard time and summer
time.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
The summer time setting you configure
●
is applied to the currently selected city
only. It does not affect other cities.
Watch Operation Guide 3521
Alarm and Hourly
The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
Snooze causes the alarm to sound up to
●
seven times, at five-minute intervals.
The alarm sound is muted in the cases
●
described below.
When battery power is low
ー
When watch is at Level 2 power saving
ー
Power Saving Function
l

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarms ([1] to
[4], [SNZ]) until the one you want to
configure is displayed.
3.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Time Signal
Alarm number
Alarm time
Alarm hour
4.
Use (B) and (D) to change the hour setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
Alarm minute
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Testing the alarm
●
In the Alarm Mode, hold down (D) to sound the
alarm.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
Turning Off an Alarm or the Hourly Time
l
Signal
Note
A beeper will sound for 10 seconds to
●
let you know when the alarm time is
reached.
The watch will automatically return to
●
the Timekeeping Mode from the Alarm
Mode after two or three minutes of non-
operation.
11