Table of Contents
Advertisement
PROGRAMMING
PROGRAMMING TRANSMITTER
CAUTION: If more motors with receiver have to be installed, it is important to power up only one
motor at time during the first programming session, in order to avoid any interferences with
others.
1
Power up the motor to be programmed.
Press and hold the PROG-TX button
2
until the motor starts moving.
Check the rotation of the motor, then
3
release PROG-TX (the motor stops).
Within 5 seconds press the
corresponding button (i.e. UP if the
motor rotates upwards or DOWN if
4
vice versa). The transmitter has been
programmed and the rotation of the
motor has been synchronized.
OFF
ON
A
Advertisement
Table of Contents
