Cleaning The Water Outlet Hose At The Siphon; Clean The Water Inlet Filters - Siemens iQ300 WM12N280HK User Manual And Installation Instructions

en Cleaning and servicing
Insert the maintenance flap and
5.
lock it into place.
Close the maintenance flap.
6.
16.6 Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
46
2
1
1
Clean the water outlet hose and si-
4.
phon connecting piece.
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
16.7 Clean the water inlet fil-
ters.
Emptying the water inlet hose
Turn off the tap.
1.
Set a programme, except for
2.
, ⁠ Spin or Drain
Rinse
Start the programme and leave it
3.
to run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
.