Table of Contents
Advertisement
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws, and
spacers are in hardware package. The hard-
ware package is provided with heater.
Attaching to Wall Stud Method
For attaching mounting bracket to wall studs:
1. Drill holes at marked locations using 9/64"
drill bit.
2. Place mounting bracket onto wall. Line
up last hole on each end of bracket with
holes drilled in wall.
3. Insert mounting screws through bracket
and into wall studs.
4. Tighten screws until mounting bracket is
firmly fastened to wall studs.
Attaching to Wall Anchor Method
For attaching mounting bracket to hollow
walls (wall areas between studs) or solid walls
(concrete or masonry):
1. Drill holes at marked locations using
5/16" drill bit. For solid walls (concrete or
masonry), drill at least 1" deep.
2. Fold wall anchor as shown in Figure 7.
3. Insert wall anchor (wings first) into hole.
Tap anchor flush to wall.
4. For thin walls (1/2" or less), insert red key
into wall anchor. Push red key to "pop"
open anchor wings (see Figure 8).
Figure 7 - Folding Anchor
Figure 8 - Popping Open Anchor Wings
For Thin Walls
200470-01A
INSTALLATION
IMPORTANT: Do not hammer anchor key! For
thick walls (over 1/2" thick) or solid walls, do
not pop open wings.
5. Place mounting bracket onto wall. Line up
6. Insert mounting screws through bracket
7. Tighten screws until mounting bracket is
Placing Heater On Mounting Bracket
1. Locate two horizontal slots on back panel
2. Place heater onto mounting bracket. Slide
www.bluegrassliving.com
last hole on each end of bracket with wall
anchors.
and into wall anchors.
firmly fastened to wall.
of heater (see Figure 9).
horizontal slots onto stand-out tabs on
mounting bracket.
Horizontal Slots
(Shown with
optional blower)
Figure 9 - Mounting Heater Onto
Mounting Bracket
Stand-Out
Tab
Mounting Bracket
(attached to wall)
11
Advertisement
Table of Contents
