Bloc 11 is used to interface 6 momentary switches or contacts. Status information is available via a potential-free relay contact. It interfaces with a Scheiber Multibloc network, in order to recover the state of the control switch and to deport the control to a power block (Bloc 9 for example).
L’innovation française depuis 1965 Technical characteristics BLOC 11 REFERENCE 41.70521.00 XXX XXX POWER SUPPLY 8-32 V DC DETAILS AND FEATURES OF THE INPUTS 6 plus digital inputs DETAILS AND FEATURES OF THE OUTPUTS 6 relay outputs 1A potential free (32V max.)
Page 4
L’innovation française depuis 1965 Seen from above CAN BUS TYCO 21-pin Connector CAN BUS Left side view CAN BUS CAN BUS STATUS LED Right side view TYCO 21-pin Connector L’innovation française depuis 1965...
L’innovation française depuis 1965 Wiring Connect to each connector: - either a CAN connection cable (to another Multibloc compatible device) - or a 120Ω impedance matching plug. 120Ω Termination cable cable cable Connect the equipment to the pins according to the numbering available in the table below, then plug the MPC connector into the TYCO receptacle.
RESPONSIBILITY LIMITS: In any case, the company SCHEIBER will not be held responsible for direct damages or damages not due to the normal use of the equipment. In case of a dispute arising between the parties, the case shall be submitted to the French Right to the court specified by the company SCHEIBER.
Page 8
L’innovation française depuis 1965 Question ? contact@scheiber.fr Problem ? sav@scheiber.fr 2 Bellevue, Phone : +33 (0)2 51 51 73 21 85120 • Saint-Pierre du Chemin sav@scheiber.fr www.scheiber.fr France...