Table of Contents
Advertisement
Handle installation
Install handle to the doorframe of the appliance.
The handle is delivered in a separated package with screws together
inside the carton.
1. Reveal two small holes on the doorframe
pulling out a bit the door seal
2. Aim the handle
inside and screw them up with screwdriver.
3.
Put back door seal
Reversing the door
Our wine cooler is delivered with the door opening from left to right. To reverse the
opening direction:
Open the door at 135 degrees and keep it steady. (be careful that the door is tall &
heavy)
Unscrew the four screws
Pull the door outwards slowly [follow the arrowhead direction in Figure 1] to get off
the lower hinge
from the top right hinge, and unscrew the two screws
plate
from the door [Figure 2].
Screw top right hinge
you want to change back left opening door in the future.[Figure 3]
Install the top left hinge
delivered in a separated polybag inside the packing carton).[Figure 3]
to the holes and insert the screws
to cover the screws.
from the lower hinge
and continue to pull the door downwards slowly until getting off
off from the cabinet and keep it in the polybag for needs if
& the lower hinge
from inner side by
from
[Figure 1].
to take off the lower hinge
to the left side of the cabinet.(
6
is
Advertisement
Table of Contents
