Table of Contents
Advertisement
Unscrew the 3 screws marked in the picture of
the LED lamp cover on top of the upper zone and
remove the LED light plug.
Unscrew the four screws that secure the LED
board, marked in the picture, replace the defective
LED lamp and reinstall the LED board.
To replace the lower zone LED
Loosen the 4 top cover plate fixing screws of the
center divider plate and remove the top cover
plate.(Note: The top cover plate should be pulled
out at the highest position, otherwise it is easy to
be scratched by the frame molding)
Unscrew the 4 screws marked in the picture,
unscrew and remove the LED board cover.
c. Unscrew the four screws marked in the picture
that secure the LED board, replace the defective
LED lamp and reassemble the board and the board
cover.
:
Advertisement
Table of Contents
