Table of Contents
Advertisement
24-Port 10/100/1000 Gigabit Switch with Webview and PoE
Acceptable Frame Type. Packet type accepted on the port. Possible values are:
• Admit Tag Only. Indicates that only tagged packets are accepted on the port.
• Admit All. Indicates that both tagged and untagged packets are accepted on the port.
PVID. Assigns a VLAN ID to untagged packets. The possible values are 2 to 4094. VLAN 4095 is defined as per
standard and industry practice as the discard VLAN. Packets classified to the Discard VLAN are dropped.
Ingress Filtering. Enables or disables Ingress filtering on the port. Ingress filtering discards packets which do
not include an ingress port.
LAG. Indicates the LAG to which the VLAN is defined.
VLAN Management Tab - Ports to VLAN
Use the Port to VLAN screen to configure port members for the selected VLAN index. Assign ports as tagged if
they are connected to 802.1Q VLAN compliant devices, or untagged they are not connected to any VLAN-aware
devices.
Select VLAN. Select the VLAN number. from the drop-down menu.
Switch Port Mode
Indicates VLAN membership mode for an interface. (Default: Access
Access. Indicates the port belongs to a single untagged VLAN. When a port is in Access mode, the packet types
which are accepted on the port cannot be designated. Ingress filtering cannot be enabled/disabled on an access
port.
Trunk. Indicates the port belongs to VLANs in which all ports are tagged, except for one port that can be
untagged.
General. Indicates the port belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1Q
mode).
Membership
Select VLAN membership for each interface by marking the appropriate radio button for a port or LAG:
Excluded. Excludes the interface from the VLAN. However, the interface can be added to the VLAN through GVRP.
Chapter 5: Using the Web-based Utility for Configuration
VLAN Management Tab - Ports to VLAN
Figure 5-14: VLAN Management - Ports to VLAN
36
Hide quick links:
Advertisement
Table of Contents
