Spanning Tree Tab - Stp Port Settings; Figure 5-45: Spanning Tree - Stp Port Settings - Linksys SRW2024P User Manual

24-Port 10/100/1000 Gigabit Switch with Webview and PoE
• Long: Specifies 32-bit based values that range from 1-200,000,000. (This is the default.
• Short: Specifies 16-bit based values that range from 1-65535.
Transmission Limit. The maximum transmission rate for BPDUs is specified by setting the minimum interval
between the transmission of consecutive protocol messages. (Range: 1-10; Default: 3) Modify the required
attributes for STP.
Click Save Settings to save the changes.

Spanning Tree Tab - STP Port Settings

The Port Information and LAG Information screens display the current status of ports and LAGs in the Spanning
Tree.
State. Shows if Spanning Tree has been enabled on this interface.
Status. Displays current state of this port within the Spanning Tree:
• Discarding - Port receives STA configuration messages, but does not forward packets.
• Learning - Port has transmitted configuration messages for an interval set by the Forward Delay
parameter without receiving contradictory information. Port address table is cleared, and the port begins
learning addresses.
• Forwarding - Port forwards packets, and continues learning addresses.
Forward Transitions. The number of times this port has transitioned from the Learning state to the Forwarding
state.
Operational Edge Port. This parameter is initialized to the setting for Administrative Edge Port in STP Port
Setting detail, but will be set to false if a BPDU is received indicating that another bridge is attached to this port.
Operational Link Type. The operational point-to-point status of the LAN segment attached to this interface. This
parameter is determined by manual configuration or by auto-detection, as described for Administrative Link Type
in the STP Port Setting detail.
LAG. Indicates if ports are members of a LAG. To configure STP port settings for LAGs, go to the table entry for the
LAG number, which is listed after port g24 at the end of the table.
Click Detail to configure STP Port Settings for an interface.
Chapter 5: Using the Web-based Utility for Configuration
Spanning Tree Tab - STP Port Settings

Figure 5-45: Spanning Tree - STP Port Settings

63