Figure 5-6: Port Settings - Port Setting Detail - Linksys SRW2024P User Manual

24-port 10/100/1000 gigabit switch with webview and poe

Hide thumbs Also See for SRW2024P:

Product data (3 pages)

User manual (156 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

page of 110

/ 110
Contents
Table of Contents
Bookmarks

Table of Contents

24-Port 10/100/1000 Gigabit Switch with Webview and PoE

Link Status. Up indicates a port has an active connection, Down indicates there is no active connection or the

port has been taken offline by an Administrator.

Speed. The connection speed of the port is displayed here. The speed can be configured only when

auto-negotiation is disabled on that port.

Duplex. This is the port duplex mode, Full (transmission occurs in both directions simultaneously) or Half

(transmission occurs in only one direction at a time). This mode can be configured only when auto-negotiation is

disabled and port speed is set to 10Mbps or 100Mbps. It cannot be configured on Link Aggregation Groups

(LAGs).

MDI/MIDX. This is the MDI/MDIX status of the port. The MDI setting is used if the port is connected to an end

station. The MDIX setting is used if the port is connected to a hub or another switch.

Flow Control. This is the flow control status of the port. It is active when the port uses Full Duplex Mode.

Type. Displays the port type.

LAG. This indicates if the port is part of a LAG.

Detail. The Detail button will open the Port Setting screen.

Port Setting

Port. Select the number of the port from the drop-down menu.

Port Configuration

Description. Allows you to describe an interface. (Range: 1-64 characters)

Port Type. This is the port type.

Speed Duplex. Allows you to manually set the port speed and duplex mode. (i.e., with auto-negotiation disabled)