Port Management Tab - Link Aggregation - Linksys SRW2024P User Manual

24-Port 10/100/1000 Gigabit Switch with Webview and PoE
• 100half - Supports 100 Mbps half-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 1000half - Supports 1000 Mbps half-duplex operation
• 1000full - Supports 1000 Mbps full-duplex operation
• Sym (Gigabit only) - Check this item to transmit and receive pause frames, or clear it to auto-negotiate the
sender and receiver for asymmetric pause frames. (The current switch chip only supports symmetric pause
frames.)
Flow Control. Enables flow control. Flow control can eliminate frame loss by "blocking" traffic from end stations
or segments connected directly to the Switch when its buffers fill. When enabled, back pressure is used for half-
duplex operation and IEEE 802.3x for full-duplex operation. (Avoid using flow control on a port connected to a hub
unless it is actually required to solve a problem. Otherwise, back pressure jamming signals may degrade overall
performance for the segment attached to the hub.
(Default: Autonegotiation enabled; Advertised capabilities for 100Base-TX – 10half, 10full, 100half, 100full;
1000Base-T – 10half, 10full, 100half, 100full, 1000full; 1000Base-SX/LX/LH – 1000full)
Port Broadcast Control
You can protect your network from broadcast storms by setting a threshold for broadcast traffic for all ports. Any
broadcast packets exceeding the specified threshold will then be dropped.
Status. To enable broadcast control on a specified port, select Enabled for that port.
Threshold. Set the threshold using the Threshold field. You may enter 64-1000000 K/bits/sec.
After you modify the required port settings, click Apply.
Click the Save Settings button to save your changes.

Port Management Tab - Link Aggregation

LAG. This indicates if the port is part of a LAG.
Description. Description for this LAG.
Administrative Status. The admin status of the LAG. Up indicates that the LAG is available. Down indicates that
administrator has taken the port offline. When modifying the option, be sure to click the Save Settings option.
Chapter 5: Using the Web-based Utility for Configuration
Port Management Tab - Link Aggregation
31