Table of Contents
Advertisement
Section 4 – Unpack/Uncrate
Section 4 – Unpack/Uncrate
After receiving your ACE Model AT Rotary Accumulation Table, carefully unpack the unit and check for
any damage. If unit is damaged, please contact the freight company. ACE can assist you with any
replacement parts you may require.
Section 5 – Setup
Floor Locks
Page | 5
Your Model AT Rotary Accumulation Table will
arrive lagged and or strapped to a pallet and
stretch wrapped to protect the exterior finish. You
may remove the stretch wrap and the lag screws
or straps from the rotary table.
Next, remove your new Model AT Rotary
Accumulation Table from the pallet and cover case
and place it in its final location.
NOTE: Do not attempt to lift the entire unit with
the eye or damage may result.
The unit may be lifted with a fork truck from under
the base plate. Lift slowly and stabilize the table
during the process.
Roll the Model AT Rotary Accumulation Table into
position on the factory floor and lock all four
swivel casters prior to use. To lock the swivel
caster, simply depress the foot pedal down until it
clicks. To release, push on the top of the pedal
until the pedal.
Advertisement
Table of Contents
