Table of Contents
Advertisement
13. All cabling joints on the outside of the camera must be properly sealed for
waterproofing.
1. Stretch the waterproof tape by twice its length and
wind around the cables.
2. The tape should overlap the cable joints by 20mm.
3. All connectors, whether they are used or not,
should be waterproof.
Cable molding
2cm
Layer - Self-fusing tape
or electric tape
14. Remove the seal on the dehumidifier breathe hole from the back of the camera. Use a
crimping plier to connect a grounding wire to the ground screw.
1
2
Remove seal
18 AWG min.
3.5mm screw mm.
Green & Yellow wires
Crimping plier
* Use knurled washers
VIVOTEK
User's Manual - 15
Advertisement
Table of Contents
