Table of Contents
Advertisement
Available languages
Available languages
Cleaning is easy because little heat is generated to the interior surfaces; therefore,
there is no baking and setting of spills or spattering. To clean the interior surfaces,
wipe with a soft cloth and warm water. DO NOT USE ABRASIVE OR HARSH
CLEANERS OR SCOURING PADS. For heavier soil, use baking soda or a mild
soap; rinse thoroughly with hot water.
Waveguide Cover
The waveguide cover is on the right side of the cavity. It is made from mica so
requires special care. Keep the waveguide cover clean to assure good oven
performance. Carefully wipe with a damp cloth any food spatters from the surface
of the cover immediately after they occur. Built-up splashes may overheat and
cause smoke or possibly catch fire. DO NOT REMOVE THE WAVEGUIDE
COVER.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup
water, grated peel and juice of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100% power. Allow to set in oven
until cool. Wipe interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed for easy cleaning. Wash
them in mild, sudsy water; for stubborn stains use a mild cleanser and
non-abrasive
scouring
sponge
as
described
above.
They
are
also
dishwasher-proof. Use upper rack of dishwasher. The turntable motor shaft is not
sealed, so excess water or spills should be wiped up immediately.
Grease Filters
Filters should be cleaned at least once a month. Never
operate the fan or oven without the filters in place.
Pull down slightly on the tab toward the front of the oven
and remove the filter. Repeat for the other filter.
Soak the filter in a sink or dish pan filled with hot water
and detergent. DO NOT use ammonia or other alkali; they will react with the filter
material and darken it.
Agitate and scrub with a brush to remove embedded dirt.
26
Advertisement
Table of Contents
