EnGenius EWS377-FIT Quick Start Manual page 4

Ceiling Mount (Hard Ceiling)
1. Screw the included Screws into the Ceiling Mount
Base with Spacers, and then screw the Screws into
the surface until they are flush with the surface.
Wall Mount
1. Determine where the Access Point will be placed and mark the location on the surface for the two mounting holes.
Use the appropriate drill bit to drill two 8.1mm diagram and 26mm-deep holes on the marks.
2. Screw the Anchors into the holes until they are flush with the wall; screw the included Screws into the Anchors but
leave the screw head sticking out so you can hang the Access Point on it.
3. Hang the Access Point against the wall onto the Screw heads.
Holes in the wall
Spacers
Screws
Access Point
Screws
Spacers
Anchors
2. Slide the Access Point into the Ceiling Mount Base.
Ceiling Mount
Base
Ceiling Mount
Base
Access Point
EWS377-FIT Quick Start Guide