Lindhaus Health Care Owner's Manual page 7

6
STEP 1 S T E P 2
O P E R A T IN G
IN S T R U C T IO N S
Switch on the machine (power
switch), depress the foot pedal (by
foot) and move the vacuum body in
working position. The brush motor
will automatically turn on.
B R U S H H E IG H T
A D J U S T M E N T
Your carpet cleaner has several built
in safeguards to protect components
from overload damage. The elec-
tronic circuitry that operates the red
light on the base indicates that the
motor is overloading because the
brush height is set too low or there
is debris hindering the movement
of the brush roller.
If the overload is excessive the cir-
cuitry will shut off the brush motor
and the red light will stay on until
the problem is corrected. When the
problem is corrected turn the switch
off, wait for a moment and turn it
back on. Make sure you unplug the
machine while inspecting the brush
roller for debris.
STEP 1. With machine on and
handle in normal operating position,
slowly rotate brush adjustment knob
clockwise until red light turns on.
STEP 2. Turn brush adjustment
knob slowly counterclockwise until
red light goes out.
NOTE: If the red light goes on and
off intermittently while vacuuming, this
is correct. If the red light stays on all
the time, turn the knob as STEP 2.
In case of fringed carpets the
machine must be used from the
center to the outside only. With one
color carpet or those whose weaves
have a tendency to form lines, it is
advisable to follow the direction of
the material to get a consistent
surface appearance.