Table of Contents
Advertisement
DO NOT PLUG IN BEFORE THE MACHINE IS FULLY ASSEMBLED
1. Insert the mixing bowl into the machine body.
2. Insert the extruding axle into the mixing bowl. Check that the front hole of the extruding axle is
clean from any residues from previous processing.
3. Select the desired molding disc and insert it into the extruding head in the correct position as
the diagram shows. Moisten the mold underneath water for a better extrusion.
Confirm the holes of the shaping disc is clean without any residues of previous dough, to avoid
breakage.
4. Insert the extruding head with the shaping disc on the tip of the extruding axle into the mixing
bowl. Wet the inside of the extruding head with water before applying it.
5. Insert the disc locking nut by spinning it clockwise. Verify that it is fully screwed in.
6. Fully insert the mixing paddle into the mixing bowl.
7. Insert the top cover on the mixing bowl, spin it until the arrow is pointing to the screen and fully
tightened. If that isn't inserted correctly, the machine won't allow any process but only displays
E02.
PLEASE WAIT UNTIL ALL PARTS OF THE MACHINE STOP AFTER THE PROCESS IS FINISHED, THEN
REMOVE THE TOP COVER.
Assembly Instructions
12
Advertisement
Table of Contents
