Bluetooth scanner -> offline mode
If you are heading for a working area which lies outside the Bluetooth signal range,
you may activate the offline mode of the scanner, following the steps described
below. Under this enhanced offline mode, all scanned data will be stored directly
into the buffer memory of the device. Furthermore, the data entries will be
permanently saved in the buffer memory prior to the manual upload into the
working station, so that you may upload them time and again to your liking.
Due to the fact that the data entries will be automatically wiped from the buffer
memory during upload, a data loss is possible when malfunctions occur during
upload, e.g. if the working station suffers a unanticipated system shut down.
An operation in offline mode is strongly recommended under the following
scenarios:
1)
During the scanning process, the device often leaves the Bluetooth signal
range;
2)
Due to a high quantity of blocking objects, the Bluetooth signal's stability can't
be ensured.
1.
By scanning the following barcode, the offline mode will be activated.
2.
By scanning the following barcode, all data in the buffer memory will be deleted
(only in offline mode).
3.
By scanning the following barcode, all data entries in the buffer memory can be
manually uploaded after reconnecting to the working station (only in offline
mode).
4.
By scanning the following barcode, the gross quantity of the uploaded data
entries will be summarised (only in offline mode).
Summarising of uploaded data entry quantity
5.
By scanning the following barcode, the device leaves the offline mode, normal
mode will be reinitialised.
Offline mode activation
Buffer data purge
Manual data upload
Quit offline mode
Need help?
Do you have a question about the BCST-10 and is the answer not in the manual?
Questions and answers