Dover HYDRO HYD10099838 User Manual

Safety Precautions

WARNING! Please read these warnings carefully and follow all applicable local codes and regulations.
TO AVOID SERIOUS PERSONAL INJURY AND PROPERTY DAMAGE:
protective clothing and eyewear when dispensing chemicals or other materials, when working in the vicinity
WEAR
of chemicals, and when filling or emptying equipment.
read and follow all safety instructions in safety data sheets (SDS) for all chemicals.
observe all safety and handling instructions of chemical manufacturer.
ALWAYS
dilute and dispense chemicals in accordance with chemical manufacturer's instructions.
regularly inspect equipment and keep equipment clean and properly maintained.
NEVER mix incompatible chemicals that pose hazards.
only to warewash reservoirs. Operating outside of these parameters will void manufacturer's warranty.
ATTACH
introduction

Package Contents

HYD10099838
DMx Inductive Probe Kit
•
Inductive Probe with attached cable and signal conditioner
Inductive interface printed circuit board for wiring the inductive
•
probe to DMx (not shown)
• Small slotted screwdriver (not shown)
A conduit fitting that threads into the base of the DMx cabinet
•
(not shown)
• A nylon wire tie wrap

Overview

The optional inductive probe kit provides a more accurate, temperature-compensated conductivity measurement inside the
wash tank. This probe is not susceptible to scaling in regions with hard water.
The following instructions explain how to install an inductive probe and connect it to a DMx dispenser.
Dispensers that are ordered with this option come with the kit packed separately.
THANK YOU FOR YOUR INTEREST IN OUR PRODUCTS!
user manual
DMx Inductive Probe Kit