Industry Canada Notices And Other Information - Panasonic KX-TG4771C Operating Instructions Manual

Industry Canada Notices and other information

NOTICE:
This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is
confirmed by the registration number. The abbreviation,
"IC:", before the registration number signifies that
registration was performed based on a Declaration of
Conformity indicating that Industry Canada technical
specifications were met. It does not imply that Industry
Canada approved the equipment.
Users should ensure, for their own protection, that the
electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system,
if present, are connected together. This precaution may
be particularly important in rural areas.
NOTICE:
The Ringer Equivalence Number (REN) assigned
to each terminal device provides an indication of the
maximum number of terminals allowed to be connected
to a telephone interface. The termination on an
interface may consist of any combination of devices
subject only to the requirement that the sum of
the Ringer Equivalence Numbers of all the devices
does not exceed 5.
The Ringer Equivalence Number (REN) of
this unit: (found on the bottom of the unit).
NOTICE:
Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Privacy of communications may not be ensured when
using this telephone.
Some cordless telephones operate at frequencies that
may cause interference to nearby TVs and VCRs.
To minimize or prevent such interference, the base of the
cordless telephone should not be placed near, or on top
of, a TV or VCR. If interference is experienced, move the
cordless telephone further away from the TV or VCR.
This will often reduce, or eliminate, interference.
RF Exposure Warning:
L This product complies with IC radiation exposure
limits set forth for an uncontrolled environment.
TG477xC(en-en)_1214_ver021.pdf 45
Useful Information
L To comply with IC RF exposure requirements,
the base unit must be installed and operated
20 cm (8 inches) or more between product and
all person's body (excluding extremities of hands,
wrist and feet).
L This product may not be collocated or operated
in conjunction with any other antenna or transmitter.
L The handset may be carried and operated with
only the specific provided belt clip. Other non-tested
belt clips or similar body-worn accessories may not
comply and must be avoided.
Compliance with TIA-1083 standard:
Telephone handsets identified with this logo have
reduced noise and interference when used with T-Coil
equipped hearing aids and cochlear implants.
Compatible with
Hearing Aid T-Coil
TIA-1083
2011/12/14
T
45
16:37:36