Klutch 49416 Owner's Manual page 16

Refer to Figure N and Figure O
19. Mount the Pulley and Belt.
a. Clean the Shaft (35) of all plastic protective material and other debris. Also clean outdebris
fromthe Drum Pulley (49) center hole.
b. Position the Drum Pulley (49) so that theSet Screwhole (48) is facing outward. Squarely push
the Pulley center onto the Shaft so that the groove in the Drum Pulley engages the Key (47).
The Pulley should be flush with the step on the Shaft. Thread the Set Screw (48) and tighten
in place.
Note: Do not pound the Drum Pulley onto the Shaft. Damage can occur resulting in a loose fit.
c. Place the V Belt (61) around the Drum Pulley (49).
Fig.N
Fig. O
Set Screw (48)
Key (47)
Drum Pulley (49)
V Belt (61)
Page 16 of 27