Klutch 49416 Owner's Manual page 12

Refer to Figure C
9. With two people, set the Drum Lower (8) with attached Support Arm assembly into Stand
assemblyso that the Shaft (35) is on the wheel side and the Iron Tube (18) is on the Support
Bracket (25) side of the assembly.
10. Insert Hex Bolts (59) with Washer through holes from one side, thenWasher and Lock Nutfrom
the other side, and tighten with a wrench.
Refer to Figure D
11. With the help of another person, attach Connector Seal (6)to the DrumLower (8), making sure that
the holes in both align. This Connect Seal must be flat on the Drum Lower to ensure a proper seal.
Refer to Figure E
12. Carefully place the Drum Upper (4) onto the Connector Seal. Make sure that the holes in both
align. Note: When placing the Drum Upper, align the Mixing Blade mounting holes in the side of
the drums as shown in FigureE. If they are too far away from each other, the Mixing Blades holes
will not match up with the mounting holes on the Drums.
Refer to Figure F
Fig.C
Shaft (35)
Bolt &Washer
&Locknut
Fig.D
Fig.E
Page 12 of 27
Iron Tube
(18)
Bolt &Washer
&Locknut
Connect Seal (6)
Drum Upper (4)
Mixer Blade
Mount holes