Image Count Programming Sequence; Image Count Off/On Programming Sequence; Setting Bulb Length Option - Pclix LT Owner's Manual

Table of Contents

Image Count Programming Sequence (4):

Turn the Pclix LT OFF

set the LEFT dial to 4, the RIGHT dial can be any number

while pushing the red Fire button turn ON Pclix LT to enter programming mode

after 3 RED LED flashes release FIRE button

the GREEN LED will flash twice telling you to enter the thousands & hundreds

set the thousands & hundreds using the LEFT and RIGHT dials

push FIRE button to enter those numbers, the GREEN LED will flash 3 times

set the tens & ones using the LEFT and RIGHT dials

push FIRE button to enter the tens & ones, the GREEN LED will flash 4 times

turn OFF the Pclix LT to exit programming mode

You've just set the Image Count.

Image Count OFF / ON Programming Sequence (3):

Turn the Pclix LT OFF

set the LEFT dial to 3 and the RIGHT to 1 for Image Count ON or 0 for OFF

while pushing the red Fire button turn ON Pclix LT to enter programming mode

after 3 RED LED flashes release FIRE button

the GREEN LED will flash 4 times indicating you have successfully set either ON or OFF

turn OFF the Pclix LT to exit programming mode

The Bulb Length Option allows you to instruct the camera as to how long the shutter

will remain open. This function is very handy if you are doing astrophotography or in other

situations where there is next to no light. In this mode the Pclix LT will send an Infrared

command to open the shutter, wait the bulb length then send another Infrared command to

close the shutter. If you are using a Contact Switch Closure the Pclix LT will close the internal

switch and keep it closed, once the length of the bulb setting is reached the internal switch is

released causing the camera shutter to close.

You are able to define a Bulb Length of up to 59 minutes and 59 seconds using the

programming mode. NOTE: Your bulb length must be at least 1 second shorter then your

interval length for this option to function correctly. To set the Bulb Length start by turning

OFF the Pclix LT. You first set the LEFT dial to 6, the RIGHT dial can be anything. Now hold

down the red FIRE button while turning ON the Pclix LT. After the 3 RED LED flashes

indicating you are now in programming mode release the FIRE button, the GREEN LED will

flash 2 times asking for you to set the minutes of your bulb length. Once set push the red

FIRE button again, the GREEN LED will flash 3 times asking you to enter the seconds of your

bulb length. Once set push the red FIRE button one last time, there will be 4 GREEN LED

flashes indicating you have correctly set the bulb length. Remember the Pclix LT will flash the

RED LED once to indicate an error if you try and enter a number greater than 59 for the

Table of Contents