Advanced Operation Mode - Pclix LT Owner's Manual

When operating in this basic time-lapse mode you can change the interval at anytime
without turning OFF the Pclix LT. Simply dial in your new interval time, the Pclix will continue
to countdown your old interval, once at zero the GREEN LED will flash and an image will be
taken. Then your new interval setting will be loaded and used from that point on.
In this Basic Operational mode the Pclix LT will continue to instruct your camera to take
an image until the Pclix LT is switched OFF, your camera battery goes dead or the memory
card becomes full.
The RED fire button can be used at anytime to take an image. For example, if during a
long interval you would like to trigger the camera for whatever reason, you can do so. Or you
can set both dials to zero and use the Pclix LT as a simple wireless remote.
Advanced Operation
In the Pclix LT "Advanced Operation" mode, you have the ability to change the way the
device functions. Various user preferences and custom timing options can be set and saved
into the Pclix LT. All settings are saved into flash memory and will stay there until further
changes are made. This means that you do not need to worry about loosing your custom
settings if the batteries need to be replaced or the Pclix LT is left turned OFF for extended
periods of time.
The programming features of the Pclix LT have been designed so you can quickly and
easily change any or all of the user preferences anywhere, anytime. There is no need to pre-
program settings using a computer or PDA before you decide what you are going to
photograph. From within the programming area you can set the Pclix LT to control various
camera models. You can define up to 10 custom user intervals, set a starting delay time, set
the number of images to be taken and define a shutter bulb length. Once these settings are
programmed you can switch these options ON or OFF independently without affecting the
selected durations or image counts.
There are three basic steps in order to put the Pclix LT into the programming mode.
The first is to make sure the power switch for the Pclix is in the OFF position. The second is to
set the LEFT hand grey dial to the user option you wish to set and in some programming
cases also set the RIGHT hand grey dial as well. The third is to hold down the RED fire button
while you turn ON the Pclix LT. If you have done this correctly the RED LED will flash 3 times.
Once the three flashes have finished you can release the RED fire button. At this point the
GREEN LED will flash from 1 to 4 times to indicate you've either completed the programming
option you wanted to set or to proceed to the next step. The software of the Pclix LT will warn
you if you have made an error or attempted to enter an illegal number. All programming
options end with the GREEN LED flashing four times indicating your settings have been saved
in memory. You must turn OFF the Pclix to exit the programming mode. Now your settings
have been saved in memory and you are free to turn ON the device.
10