Setting Image Count Option - Pclix LT Owner's Manual

Delay Start OFF / ON Programming Sequence (1):
- Turn the Pclix LT OFF
- set the LEFT dial to 1 and set the RIGHT to 1 for Delay ON or 0 for Delay OFF
- while pushing the red Fire button turn ON Pclix LT to enter programming mode
- after 3 RED LED flashes release FIRE button
- the GREEN LED will flash 4 times indicating you have successfully set either ON or OFF
- turn OFF the Pclix LT to exit programming mode

Setting Image Count Option (4):

The Image Count Option allows you to tell the Pclix LT how many images to instruct
your camera to take. Once that number is reached the Pclix LT will stop instructing your
camera to take additional images and indicate your sequence is finished by flashing the RED
LED once every 3 seconds until you shut OFF the device. You can program the Image Count
to any number of images between 1 and 9,999. This option is handy to stop the camera from
continuing to take images once the memory card is full. Also if you know the final frame count
of your sequence, you can set the Image Count to that number and have the camera stop.
Programming this option is accomplished basically the same way as other options on
the Pclix LT. You first must turn OFF the Pclix LT, then set the LEFT dial to 4, the RIGHT dial
can be anything. Now that the dials are set, hold down the red FIRE button and turn ON the
Pclix LT, after the 3 RED flashes release the FIRE button, the GREEN LED will flash 2 times.
Let's say for example; you want your camera to take 1547 images. Set the LEFT dial to the
thousands, in this case 1 and the RIGHT dial to the hundreds which is 5 in our example. With
these two dials set, push the red FIRE button. The GREEN LED will flash 3 times asking for the
tens and ones which in our example the LEFT dial should be set to 4 and the RIGHT dial set to
7. Now push the red FIRE button to enter the last two numbers of your Image Count. At this
point the GREEN LED will flash 4 times to indicate your Image Count has been set. Turn OFF
the Pclix LT
Like the Delay Start Option, the Image Count must also be turned ON in order to use it.
You can turn it ON by setting the dials to 31 and entering programming mode in the usual
way, or OFF by setting the dials to 30 and entering the programming mode.
The Image Count Option let's you know if it is ON or OFF during normal startup. In
normal mode the GREEN LED will flash 3 times during startup, if the Image Count Option is
set ON then the RED LED will flash during the second flash of the GREEN LED at startup.
Once your Image Count is finished the RED LED will flash every 3 seconds to indicate
your sequence is finished shooting. To clear the Pclix LT after shooting your sequence turn
OFF the device. If you turn the Pclix LT back ON it will repeat the Image Count down until you
set the Image Count Option OFF.
15