Table of Contents
Advertisement
So to program the Delay Start turn OFF the Pclix LT as you always need to do in order
to get into programming mode. Then set the LEFT dial to 2 and hold down the red FIRE button
and turn ON the Pclix LT, after the RED LED flashes 3 time release the FIRE button.
The GREEN LED will now flash once indicating you need to enter the delay hours using the
LEFT and RIGHT dials. Once you've set the hours push the red FIRE button, the GREEN LED
will flash 2 times indicating you now need to enter the minutes for the delay. Set the dials for
the minutes and then push the red FIRE button again, you'll see 3 GREEN flashes/ Now all
that's left to do is program the seconds, set the seconds and push the FIRE button one last
time. You should now see the GREEN LED flash 4 time which means you have successfully
programmed a Delayed Start Time. Turn OFF the Pclix LT.
The next step is to turn ON the Delay Start Option. In order to do this you must put the
Pclix LT into programming mode one more time. Set the dials to 11 and startup the Pclix LT in
the programming mode. Once you release the red FIRE button the GREEN LED will flash 4
times indicating you have now turned ON the Delay Start Option. Now turn off the Pclix LT to
exit programming mode. You've now programmed the Delay Start time remember you must
turn ON the Delay Start Option using the Programming code of 11 in order to use it. To shut
OFF the Delay Start Option you would use the programming code of 10. NOTE: If you plan on
using the Delay Start Option it is advised that you confirm your camera is receiving
commands by pushing the red FIRE button a few times at the beginning of the Delay Start
countdown.
The Pclix LT will let you know what Options you have set ON or OFF. In the Delay Start
Option, it does this during the LED startup sequence when the Pclix LT is turned ON. In
normal mode the GREEN LED will flash 3 times during startup, if the Delay Start Option is set
ON then on the first flash of the GREEN LED on startup the RED LED will also flash at the
same time to indicate the Delay Start is ON.
When the Pclix LT is counting down the Delay Start time the GREEN LED will flash once
every 3 seconds to indicate you are in the process of counting down the delay. Once the Delay
Start time reaches zero then Pclix LT will instruct your camera to take pictures as normal.
Delay Start Programming Sequence (2):
-
Turn the Pclix LT OFF
-
set the LEFT dial to 2, the RIGHT dial can be any number
-
while pushing the red Fire button turn ON Pclix LT to enter programming mode
-
after 3 RED LED flashes release FIRE button
-
the GREEN LED will flash once indicating to enter the Start Delay hours
-
set the Delay Start hours using the LEFT and RIGHT dials
-
push FIRE button to enter the hours, the GREEN LED will flash 2 times
-
set the Delay Start minutes using the LEFT and RIGHT dials
-
push FIRE button to enter the Delay Start minutes, the GREEN LED will flash 3 times
-
set the Delay Start seconds using the LEFT and RIGHT dials
-
push FIRE button to enter the seconds, the GREEN LED will flash 4 times
-
turn OFF the Pclix LT to exit programming mode
-
You've just set the Delay Start time.
14
Advertisement
Table of Contents
