Eastwood Elite 55252 Instructions Manual page 10

ADDING COOLANT MIXTURE
The Eastwood Elite TIG Water Cooler is specifically designed to operate at peak effectiveness
with a mixture of deionized water and #55263 Eastwood TIG Torch Water Cooler Coolant Additive
which also eliminates bacteria growth and freezing. It can be pre-mixed with water or by fluid level
measurement in the Reservoir.
If deionized water is unavailable and tap water must be used, it becomes a necessity to use
#55263 Eastwood TIG Torch Water Cooler Coolant Additive to help avoid bacteria buildup,
corrosion and clogging.
If extended welding sessions require frequent coolant replenishment and replacement, the
TIG Water Cooler Additive may be omitted however, the TIG Water Cooler system MUST be drained
and dried out after each use.
Ice may be added to the Reservoir to lower the Coolant temperature however, the TIG Water Cooler
system MUST be drained and dried out after use.
DO NOT store the TIG Water Cooler without #55263 Additive or corrosion, con-
tamination, fungus and bacteria growth will occur preventing proper function
of the TIG Water Cooler system.
PRE-MIX COOLANT METHOD
- 150 oz. (1 Gallon & 22 oz.) [4.4 liters] of cool,
deionized water.
- 15 oz. [0.44 liter] of # 55263 Eastwood
TIG Torch Water Cooler Coolant Additive.
10
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com