Advertisement
Note:
Install the photoconductor unit with its protective sheet
in place. Do not remove it yet.
9.
Hold the photoconductor unit as shown below, and
insert it firmly into the slot making sure that the
bottom of the unit slide into the guide rails.
c
Caution:
Make sure the photoconductor unit is inserted
correctly. Otherwise, it may damage the printer.
Note:
Make sure that the unit is completely inserted into the
slot. Otherwise, the lever cannot be restored to a position
that accommodates the waste toner collector.
10. While keeping the photoconductor unit in place
with your left hand, pull the ring toward you to
remove the protective sheet.
c
Caution:
Failure to remove the protective sheet may
damage your printer.
11. Turn the large lever clockwise, until the lever rests
on the photoconductor unit as shown below.
7 7 7 7
Advertisement
