Advertisement
Messages
Description
This message appears when
Check Paper
Paper Type is specified with
Type
Paper Source set to Auto and
there is no paper feed unit with
paper that matches the Paper
Size and Paper Type settings.
The engine sensor is dirty. Open
Clean Sensor
the front cover and remove the
waste toner collector
temporarily. Turn the large
green lever counterclockwise
to an upright position, then
return it to its original position.
Reinstall the waste toner
collector and close the front
cover to clear this error.
Printing by specifying the
Collate was
disabled
number of copies is no longer
possible due to a lack of
memory (RAM) or free disk
space on the Hard Disk Drive. If
this error occurs, print only one
copy and end printing.
The side cover of the standard
Cover C1 Open
lower cassette is open. Close
the cover and the error is
automatically cleared.
Messages
Description
The cover of the optional 500-
Cover C2 Open
Sheet Paper Cassette Unit is
open. Close the cover and the
error is automatically cleared.
There is not enough memory for
Duplex Mem
duplex printing. The printer prints
Overflow
only on the top side and ejects
the paper. To correct this error,
follow the directions below.
If Auto Cont is set to Off in the
SelecType Config Menu, (1)
press Continue or (2) reset the
printer by pressing the ALT and
Reset buttons at the same time.
If Auto Cont is set to On in the
SelecType Config Menu, the
error is automatically corrected
after a certain period of time.
An unformatted ROM module
Format Error
has been inserted. If the ROM
ROM A/Format
module has been formatted,
Error ROM B
but is unreadable, format it
again. If the ROM is still
unreadable after reformatting,
take it to your dealer for repair
or replacement.
To clear this error, either press
the Continue button or turn off
the printer and remove the
ROM.
21
21
21
21
Advertisement
