Table of Contents
Advertisement
Figure 2-3: Model 5646A Operating Instructions
3.0 OPERATION
To use the Model 204 as a charged plate monitor, install the Charged Plate
Detector onto the front of the unit. To measure the charge build-up on personnel
or moving objects, plug a clip lead, probe or wrist strap into the detector plate.
Ground the detector plate by depressing the ZERO/RESET button for
approximately 1 second. Release the button. Any voltage generated will be
transferred to the plate and measured directly by the static meter in Volts.
To install the 6"x6" (152x152mm) plate, plug it into the 2 banana jacks on the
detector plate. Make sure the plate is seated fully so that the ends of the banana
plugs fit into the holes in the lower plate.
7
Advertisement
Table of Contents
